ilovefuzz.com

Posted: **Wed Sep 28, 2011 3:22 pm**

I'm trying to figure out if this switch setup will work or not. Basically, I have a momentary switch (normally open/off) that I added a toggle to. The idea is that, the toggle will either:
UP, function on
DOWN, momentary switch engaged. When pushed, function is on.

Here's the picture I drew

: Momentary with hard toggle.jpg (23.14 KiB) Viewed 664 times

Posted: **Wed Sep 28, 2011 3:44 pm**

yep. should work.

Posted: **Wed Sep 28, 2011 4:52 pm**

Awesome! I thought it would, but switches are confusing.

Posted: **Wed Sep 28, 2011 5:51 pm**

Jero wrote:Awesome! I thought it would, but switches are confusing.

Aren't they?

Fuckers.

ilovefuzz.com

Will this switch setup work?

Will this switch setup work?

Re: Will this switch setup work?

Re: Will this switch setup work?

Re: Will this switch setup work?