synthezatory wrote:That sucks, she should've at least offered you to check on the pedal.. Hmm. I guess that's a red flag for me
I guess she thinks I'm here in England what the hell can I really do about it. The more people I've talked to the more it sounds like customer service is a weakness at Devi Ever HQ. It has made me think twice about buying direct from her, although I do still like the stuff she makes. In future I'll stick to buying through the UK supplier of DE pedals, if anything does go wrong, I can send it back to them and its their problem. The fact this TP was on at $60 is what lured me in!
She should just let me build all her stuff
Less rats nest, less tape, less issues.
Totes about to build a TP/Aenima/KP and call it the AenimatoPeakerParty(inmuhpantz)
Wish I'd taken a photo of the guts before I sent mine back. Y U PUT ALL THIS TAPE? Am I being a dick for assuming that Charlotte building these is part of the problem since both of the problems in this thread were recent Charlotte builds? Yeah, probably being a dick....
Ragged Trousers wrote:Sent my Shoe Gazer back. We'll see what the shop says. Thankfully I bought it from a UK based shop, so returning it wasn't an issue.
Scruffie wrote:Had a look in it today, as suspected, no grounding via the pots or jack and the jacks have undue stress from being pushed up by the switch.
A circular file and quick solder later and hopefully it's all good now when I test it tomorrow.
Scruffie wrote:Had a look in it today, as suspected, no grounding via the pots or jack and the jacks have undue stress from being pushed up by the switch.
A circular file and quick solder later and hopefully it's all good now when I test it tomorrow.
any curiosity to peek under the tape?
If it's still noisy and needs more debugging I will, looks like there's quite a bit to get off though and i'm not particularly interested in the circuit (schematics are out there) as long as it's doing its job properly
JohnnyC wrote:any curiosity to peek under the tape?
Not much to look at under there. Just a circuit board with a few parts on it, like most. They are taped because it's the easiest (lazy) way to "protect" the circuit board.
Scruffie wrote:Had a look in it today, as suspected, no grounding via the pots or jack and the jacks have undue stress from being pushed up by the switch.
A circular file and quick solder later and hopefully it's all good now when I test it tomorrow.
Thank you Scruffie, for all your help, it's been greatly appreciated.
Okay... so I tested it, hum had gone down but noise still at both ends of the texture pot and it barely seemed to do much.
So took the electrical tape off, noise had gone straight away... going to investigate a bit more, see if the tape is conductive, 2 parts were shorting or there's a poor solder joint.
Sorry Smarty, looks like i'm not posting it today!
Am I being a dick for assuming that Charlotte building these is part of the problem since both of the problems in this thread were recent Charlotte builds? Yeah, probably being a dick....
