ilovefuzz.com

Turned out awesome

https://www.instagram.com/p/B2VAUV_HBHa ... dow5b0ulry

Bought a thread cutting set and a rod.

Step one: thread rod end

Step 2: make the 90 degree bend by bridge

Step C: bend bar to shape

4: cut excess rod off and deburr the tip and wet sand to desired finish/ polish

Nice! I wanna try to do that some time. Cool guitar too!

Bad ass.

Dumb question, but how did you do the bends?

adamajah wrote:Bad ass.

Dumb question, but how did you do the bends?

I used a table vice. You put the rod in so it’s vertical, then bend it down. It’s easier to bend if you use the whole rod for more leverage. I would really struggle bending it in its current state

JonnyAngle wrote:

adamajah wrote:Bad ass.

Dumb question, but how did you do the bends?

I used a table vice. You put the rod in so it’s vertical, then bend it down. It’s easier to bend if you use the whole rod for more leverage. I would really struggle bending it in its current state

No way hah. That was the way I was going to make one of my whammiejammies angled a little lower. I thought it was a janky technique. But hey if the great Jangle does it, it must be legit

I bought a thread cutting and tapping set for $26 and rod at Home Depot for $4.

Just diyityourself