Page 1 of 2

HALP E-merganceeeeeeeee

Posted: Sat Oct 19, 2013 9:38 pm
by snipelfritz
:( :( :( :( :(

My headphone's 1/8" plug broke off in my laptop's audio input. The smaller innie niblet is stuck in there.

This means no more music, or sound or anything for me. :cry:

I can't get it out, any help ideas? Reward for successful removal will be hugs and a beer on me.

Re: HALP E-merganceeeeeeeee

Posted: Sat Oct 19, 2013 9:39 pm
by sonidero
Tiny tweezers... Forceps...

Re: HALP E-merganceeeeeeeee

Posted: Sat Oct 19, 2013 9:41 pm
by snipelfritz
I haz tweezers, but they're not tiny enough, I file them?

Re: HALP E-merganceeeeeeeee

Posted: Sat Oct 19, 2013 9:43 pm
by sonidero
How handy are you??? You could open the laptop and push it out, or file tweezers or find smaller ones...

Re: HALP E-merganceeeeeeeee

Posted: Sat Oct 19, 2013 9:52 pm
by snipelfritz
ugh, I'm not particularly handy, but sometimes I surprise myself.

A'ight Ima try and open this bitch up...(don't worry it's looooooong beyond warranty)

Re: HALP E-merganceeeeeeeee

Posted: Sat Oct 19, 2013 9:54 pm
by sonidero
If I don't hear back I'll assume the worst...

Re: HALP E-merganceeeeeeeee

Posted: Sat Oct 19, 2013 9:59 pm
by Rob Fossil
take a needle or pin , heat the tip up with a lighter for about 20 seconds .
push it in the remains of the headphone plug (the part that is stuck in your device) , let it cool for about 30 seconds , then carefully pull it out. fastest and easiest way to get it out.

Re: HALP E-merganceeeeeeeee

Posted: Sat Oct 19, 2013 10:00 pm
by MEC
Dip a pin head in a small amount of superglue then put it in the jack and hold it in place until it dries. Once it's dry pull it out and hope the piece comes with it.

Be careful not to use too much glue or to get it on the sides of the input.

Re: HALP E-merganceeeeeeeee

Posted: Sat Oct 19, 2013 10:01 pm
by sylnau
Listen to that guy:
[youtube]http://www.youtube.com/watch?v=NK7FePLoofc[/youtube]

Re: HALP E-merganceeeeeeeee

Posted: Sat Oct 19, 2013 10:08 pm
by Mudfuzz
Get a drill and drill and small hole in the broken nub then take the bit and use it to grab hold of it and remove.

Re: HALP E-merganceeeeeeeee

Posted: Sat Oct 19, 2013 11:29 pm
by ryan summit
same shit happen to my ipod
gotta watch that vid

Re: HALP E-merganceeeeeeeee

Posted: Sat Oct 19, 2013 11:31 pm
by snipelfritz
lol where were these great suggestions before I took my whole laptop apart?

which didn't help at all.

I'm too pissed now from fitting all the tiny screws back into place to mess with this anymore now. (in fact some of the screws I just gave up on)

but obviously my laptop is still functional.

Re: HALP E-merganceeeeeeeee

Posted: Sat Oct 19, 2013 11:54 pm
by sonidero
Drills and super glue are both bad around computers... Maybe you learned a new skill, there still should be some way to get it out...

Re: HALP E-merganceeeeeeeee

Posted: Sun Oct 20, 2013 12:07 am
by AxAxSxS
A giant electro magnet.

Re: HALP E-merganceeeeeeeee

Posted: Sun Oct 20, 2013 12:42 am
by Decibill
You could definitely tap and drill it out.....but this does require skill and tools. Where are you located...?