Page 1 of 1
CV madness!
Posted: Fri Apr 27, 2012 5:16 pm
by aen
Just uploaded a really long piece of shit.
Flying pretty much blind with a table full of moog gear and a passive CV splitter.
[soundcloud]http://soundcloud.com/dwarfcraft/death-by-synth[/soundcloud]
Re: CV madness!
Posted: Fri Apr 27, 2012 5:28 pm
by excane
Re: CV madness!
Posted: Fri Apr 27, 2012 5:47 pm
by skullservant
Just got my Minitaur yesterday, I'll record some demos and post them here too!
Re: CV madness!
Posted: Sat Apr 28, 2012 4:35 am
by behndy
BOOM.
Re: CV madness!
Posted: Sat Apr 28, 2012 11:50 am
by aen
Kind of came up with a project as i did this. Planning on doing a lot of sample farming first. All hardware synths and effects. AND DRUMS.
Re: CV madness!
Posted: Sat Apr 28, 2012 12:13 pm
by jrmy
aen wrote:Kind of came up with a project as i did this. Planning on doing a lot of sample farming first. All hardware synths and effects. AND DRUMS.
I LIKE THE CUT OF YOUR JIB, GOOD SIR. I LIKE IT VERY MUCH INDEED!

Re: CV madness!
Posted: Sun Apr 29, 2012 12:46 pm
by skullservant
This is my first attempt at successfully running the Minitaur only on CV.
Carrier Oscillator Output from Moog Moogerfooger Ring Modulator -> Gate Input of Minitaur. LFO Output from Moog Moogerfooger Ring Modulator -> Attenuator-> Pitch CV Input on Moog Minituar -> Audio Output of Minitaur -> Moog Moogerfooger Ring Modulator -> Circuit Bent PT2399 Delay -> Circuit Bent DOD DFX 9 Delay (2 Second Mode) -> Strymon TimeLine (Octave Ice Mode) -> Computer
[soundcloud]http://soundcloud.com/skullservant/study-for-minitaur-cv[/soundcloud]
Re: CV madness!
Posted: Sun Aug 26, 2012 8:46 pm
by sonidero
HEY YOU GUYS...
I was like Ratt going round and round trying to figure out how to make the Minitaur hold a note... I tried adding hardware and midi cc's and stupid stuff (Minitaur wont except cc 66, or 69)...
Then

I plugged a TRS patch cable all the way into the Gate CV and then halfway into the Pitch CV and played notes from through the Midi and...

INSTA DRONE

...