ilovefuzz.com

Delta- I'll be shipping it out with those BC109's, but if you find that you want to try out different transistors in the circuit I can definitely send you different ones to try out. I meant to include some different ones in the box but I was in a rush this morning packing it up

It's also LOUD AS HELL. Seriously, I love a good volume knob on a fuzz. I think I had it around 10 o'clock and that was a boost!

thread subscribed

SO EXCITE

PumpkinPieces wrote:ALSO, WHAT IS THIS FUNERAL HORN? I SEARCHED THE THREAD AND DID NOT FIND SUFFICIENT INFO. I LIKE THE NAME. TELL ME BOUT DAT.

skullyman dropped the deets, i just wanted to chime in and say that the funeral horn is a freakin' beast and crazy versatile. could not do without mine now... could not be happier.

ps: skulls, i know your plate is full, but when you got some time for a little project (not the mega-rehouse we talked about before) gimme a shout! also i still got dem chickenhead knobbies for ya...

Sounds good man.

I fucking ran out of wire today, so I can't get QUITE as much as I wanted finish this weekend, but I will be able to spend a lot of time with the WSG which will be nice since everything with that is already wired up. Looking forward to finally getting that one shipped out.

Had everything sitting for Foomanfat's Tone Machine so I wired it up in about a half hour:

sharp! big bad wolf, eh?

WOLFSHIRT!!

WUT!?

The etching on dat ToneMachine! Amazing!

Thanks to Dan the Wizard!

Ugh, I can't wait for Mr. Foxx to get here!

UHHH MAHHH GAWD....Dat DarthFace fucking rocks! I haven't played it on the Orange yet but it sounded AMAZING. I love how the drive knob just tightens it up.

Glad you dig it Delta! And I can't wait for you to get the Foxx either Fooman!

Update:

-Spent about 4 hours with the WSG and again it is apart so I can rewire it.
-Took the_carl's Little Big Muff apart and installed the 3PDT switch and associated wiring, along with LED bezel and DC jack.
-Took DOS' DOD Apart and wired for true bypass (was a tight fit) as well as installed LED bezel and LED, along with DC jack and battery snap and took the stock diodes out and replaced them with sockets.

Going to rewire the WSG one last time as I think there might have been some wiring errors on my part with the switches. I felt the chip get warm while I had it running so I shut it off, I'm not about to fry the chip in it.

Next moves:

-Going to rewire the WSG this week again when new wire comes and see if it fixes anything.
-Going to look into tone bypass on the Little Big Muff, as well as adding a pot for the tone and wire the whole thing up.
-Going to look into how to wire up the DOD board for true bypass, replace the caps I need to for more low end, and figure out what value the diode pot is.

I also finished up a Rangemaster that I will have up for sale in the near future. Battery disconnect switch, treble/full range switch, and a three way cap select on the full range side.

Siiiiick. Thanks again for keeping it battery powered.