ilovefuzz.com

I want that.

multi_s wrote:so imagine it more as a 2 channel mixer with both inputs set to unity.

I like this approach a lot, I see it as one more not-a-regular-delay-pedal feature

Mission Control Bass Overdrive, seperate Bax tonestacks on both the clean and the drive channel, stompable boost on the drive channel, clean and drive mixer as well as master volume.

multicoloured ribbon cable and tubes. together at last.

did you have to sort through another 1000 FET's to get this new batch done? you must have huge piles of leftovers.

eatyourguitar wrote:did you have to sort through another 1000 FET's to get this new batch done? you must have huge piles of leftovers.

OTA Based by the look of it.

Gemini (the one at the front) is OTA, 4 x LM13700.

Sonic Death Ray (the one at the back) is FET, 14 x 2n5485 (and 4 x TL084, which might be being mistaken for OTAs).

So yeah, there's a whole factory somewhere in China entirely given over to producing huge quantities of unmatched FETs just for me to sort through....

Ahhh yeah, didn't notice the two seperate boards as the layouts were simmilar.

Clarinot with the clean kill and lfo option


The Shambler. Some fuzz running into PT2399. Normal channel/wet channel with a toggle to get some sick vibrato sounds.

good god man. that ClariWHAT??!? is fucking beautiful.

meee. OW.

Trim pot on switch

Jero wrote:Trim pot on switch

I was improvising! Basically, i wanted to switch between a 10k resistor which mixes the fuzz and delay about 50/50 and a 10k pot to dial out
the straight fuzz signal. Really gross ugly sounds. The toggle kicks in a 5k delay pot and jumpers the delay pin (can't remember pin #) to the one next to it, which is a .047uf to ground. With the 5k there's a small range in the middle of the rotation where you can find some sweet oscillating vibrato sounds. A very sea sick vibrato/psychoto mode.

That's awesome.