I'm building a DeadendFX Lovetone Ring Stinger Clone and having a bit of an issue with it. Some stuff works, some stuff doesn't and I'm trying to figure out locations of potential problems. First thing I'm looking at is the wiring for the sockets: https://i.imgur.com/txAYT0v.png
I am confused as to where the "SW," "TSW" and "REF" wires go using these sockets: https://d1aeri3ty3izns.cloudfront.net/m ... review.jpg
On these sockets there are 3 in a row that have contact to the sleeve, mid sleeve and tip, the other 3 in a row seem to not be connected to anything. For the wires coming from "CARR" would the "SW" go to the same lug as the tip? Or would it be wired to the other side which seems to go no where?
Would "REF" go to the mid sleeve on the side that touches the jack, or to the side that does not?
Another point that seems screwy is there are a couple trim pots which are 100k, for some reason when I hook a multimeter up to the lugs of Trimpot 2, it maxes out at about 7.4k...that can't be right can it?? Shouldn't the trimpot max at around 100k when the little screw reaches its limit and starts "snapping"
The fuzz seems to work, the timber seems to work, pedal is being weird with the ring mod and makes a constant sound that I can manipulate with the VCO rate, depth...square wave setting on the 3P4T seems to cut out the signal. LFO seems to work.