Clari(not) Clone question

[nieh]

I just got a clarinot clone with a fuzz lift, but even with the fuzz of there's a slight distortion when playing on the lower strings. Anyone know how I can fix this?

[Nocentelli]

Try a series resistor at the input: You could put a 100k pot there and dial it around until you get the desired cleanliness, and replace it with the appropriate fixed value. This resistor will also slightly reduce the fuzz amount when you switch it back in, so you might want to replace the fuzz switch with a DPDT wired so one pole shorts pin 1-8 and the other pole shorts the new resistor.

[stradivari310]

It may be the PT2399 itself distorting, in which case you could always try putting a green LED on pin 7, a la John Patton. Works amazingly well.

[eatyourguitar]

It may be the PT2399 itself distorting

that would be my guess. probably just a volume issue.

[Addy Bart]

It may be the PT2399 itself distorting, in which case you could always try putting a green LED on pin 7, a la John Patton. Works amazingly well.

.

[doug deeper]

It's because the fuzz lift is a terrible mod haha.

[doug deeper]

If you'd like a truly clean clari, add a buffer on the front end (I use a jfet), split the signal to the 386, and the pt2399.
Replace the 100k resistor that feeds the PT with a 12k resistor.

For the buffer a standard J201 1m 10k setup, with two 10uf caps (one to the delay chip, one to the env follower).

[doug deeper]

And scrap the volume pot.
This can be made switchable, but it's a bit of a task.

[Addy Bart]

Thanks Doug! I did this using a 2n5457 and it worked a charm.

[Addy Bart]

Without the volume pot, does it still need the 100n cap? I built it without and it's working but there's a loud pop (probably because I forgot the 1m pull down resistor). I'm wondering if the 100n on the end is necessary for decoupling DC from the output?

[drolo]

Without the volume pot, does it still need the 100n cap? I built it without and it's working but there's a loud pop (probably because I forgot the 1m pull down resistor). I'm wondering if the 100n on the end is necessary for decoupling DC from the output?

I'd say better to keep the cap in there to block DC coming from the pt2399 but add a pull down resistor instead of the volume pot to avoid popping.
It can be lower than 1M though. 100k is fine.

[Addy Bart]

Without the volume pot, does it still need the 100n cap? I built it without and it's working but there's a loud pop (probably because I forgot the 1m pull down resistor). I'm wondering if the 100n on the end is necessary for decoupling DC from the output?

I'd say better to keep the cap in there to block DC coming from the pt2399 but add a pull down resistor instead of the volume pot to avoid popping.
It can be lower than 1M though. 100k is fine.

Thanks David, I'll give this another try. Be cool to get rid of the pop.
I previously had the cap and 100k resistor on the board (can't remember if it popped or not ) but after some 'experimenting' with a mosfet boost, I had a horrendous mess of a perf board that I can't be bothered to untangle.
Should be able to add these off board though. Cheers.