Count To Five

[multi_s]

any chance of midi presets?

there is no midi on ct5.

so, no?

[JonnyAngle]

any chance of midi presets?

there is no midi on ct5.

so, no?

can you just add it? LOL

[whoismarykelly]

Any time you start a question with "can you just..." the answer is usually 'no.'

[goroth]

Can you just not add it?

[UglyCasanova]

I could need a SCART output, because Europe and stuff.

(New update sounds good!)

[multi_s]

ya, no.

maybe eventually there will be a unit that is what the ct5 was to gb24, but for now i am working on some different units entirely, and just updates for the current ct5.

s

[DRodriguez]

for now i am working on some different units entirely

Can't wait to see what you and the team come up with next!

[goroth]

Ct5 is fucking awesome.

Thanks Scott.

Just in case this message ever gets lost in the stream of other comments/requests/questions.

Yep, psyched to hear what's coming next!

[tremelo68]

Very cool pedal. Just adding my 2 cents so that I can be subscribed to this thread. Because, I don't see a subscribe button anywhere...

[fostewi]

Anyone know if you can safely run a synth into the ct5 without damaging it? I realize the sound may not be great because of the higher signal level but I don't want to even try it if there is a chance of damaging the ct5. The output specs of the synth is ”Unbalanced Output; Nominal ± 1.5 Volt Signal". Note there is no output volume control so I can't turn it down to be safe unless I use something else to attenuate it first. I can only imagine how good this could sound! Thanks.

[multi_s]

it will probably clip a bit at that level but will not damage it.

[UglyCasanova]

I've played microkorg->CT5 and it's great

[Willem]

I run my Sub Phatty through my pedalboard (with CT5 on it of course), I use a LS-2 as mixer to attenuate the synth and have +/- the same input volume as my guitar and it works fine!

[fostewi]

Thanks everyone for the replies...I tried it quickly with my pedal board and found many pedals had little to no effect (especially dirt) and ct5 worked but did not sound great..I def have to look at getting something to attenuate the output so I can explore this further. If I was to mod my werkstatt to have an output volume control would that be sufficient or should attenuation be done using some other means so signal is still high enough quality?

Edit: maybe this attenuator cable (https://koma-elektronik.com/?product=ko ... ator-cable) with a 1/4 to 1/8 male mono cable would do the trick? The adjustment range is not very fine/accurate but maybe would work well enough to reduce the signal down to closer to instrument level.

[JonnyAngle]

I don't attenuate shit, works great.

This