I have a PDF where I describe the process of uploading code to EEPROM chips for bank 4. It's in Norwegian but might still be useful? I won't be sharing any code sorry
Thanks, I was mostly just curious about coding my own patches for it. When you ran the workshops, did you have people coding their own patches or did you give them ready-made stuff they could plug in as they wanted?
A little different from workshop to workshop. The goal is to write a new program each workshop which does not always work out. Then we look over some code I've made and some programs from the spinsemi forum.
I didn’t put one in my cart, and I didn’t pay for it either, and I still didn’t get one. I haven’t emailed about this problem, and you still haven’t replied yet. Can you guys look into this issue for me? I hope Swedish post hasn’t lost my Form!
goroth wrote:I didn’t put one in my cart, and I didn’t pay for it either, and I still didn’t get one. I haven’t emailed about this problem, and you still haven’t replied yet. Can you guys look into this issue for me? I hope Swedish post hasn’t lost my Form!
goroth wrote:I didn’t put one in my cart, and I didn’t pay for it either, and I still didn’t get one. I haven’t emailed about this problem, and you still haven’t replied yet. Can you guys look into this issue for me? I hope Swedish post hasn’t lost my Form!
My Form2 arrived today! I'm just getting to know it, but t's really fun to play with.
One small issue, which I only mention in case it helps someone else. The daughter board had separated a little bit during shipping so the pedal didn't engage properly. I opened it up, pushed the daughter board down to re-seat it, and all was right with the world.
Glad it worked out! I'll say the circuitboard solution for FORM2 isn't my best decision. It was made that way to make the design workshop friendly. If you're doing a lot of traveling/touring it might be a good idea to place a non-conductive material inside the enclosure lid to more firmly keep the Daughter PCB in place. I expected my zip tie solution to be solid.. If any of ya'll have any further issues with the pedal don't hesitate to contact me on info@pladaskelektrisk.com
Pladask wrote:I have a PDF where I describe the process of uploading code to EEPROM chips for bank 4. It's in Norwegian but might still be useful? I won't be sharing any code sorry