Moderator: multi_s
…...........................…psychic vampire. wrote:The important take away from this thread: Taoism and Ring Modulators go together?
oldangelmidnight wrote:You could also try a Korg SQ-1 and use the 2v limit.
hotfat wrote:I went through this a little bit already. In my experience, the CT5 just ignores CV greater than 3.3vdc up to 5vdc. A simple resistive voltage divider suggested by Scott worked great to force the range of 0 to +5vdc to a max of +3.3vdc. Scott, I hope you don't mind me quoting here …
"One way to do it would be to have a CV from your synth going to a TRS cable, with the voltage on the Tip and the Ground on the Sleeve. Leave the ring disconnected. This *should* work ok as long as the input is 0-5V BUT the pedal will only respond to 0-3V, and at 3V it will just stay at "max" even if the CV passes this voltage.
SO the absolute best way to do it, and definitely waht i would recomend, would be to get 2 resistors wit ha 2:3 ratio,like 220k and 330k say (very common values) and use it as a voltage divider from your 0-5V out to scale it to 0-3, then plug that into the TRS as described in the previous paragraph and everything should be good, and it will respond to the full 0-5v scale, because you actually just shrank it to 0-3V. You could probably cram the 2 resistors into the shell of the TRS and just have one slick magic cable "
multi_s wrote:the CT5 just ignores CV greater than 3.3vdc up to 5vdc.
stelpa wrote:multi_s wrote:the CT5 just ignores CV greater than 3.3vdc up to 5vdc.
Thanks for the response, good to know
I'm mentioned in an edit before but I'm not sure if you saw it - you said earlier in the thread that you'd be able to add the alternate latching softswitch behavior for 0.941k to the current firmware version - are you still planning on doing that? I know you're busy and I don't mean to bother, just figured I'd ask since it would help me a lot. Thanks a bunch!
multi_s wrote:stelpa wrote:multi_s wrote:the CT5 just ignores CV greater than 3.3vdc up to 5vdc.
Thanks for the response, good to know
I'm mentioned in an edit before but I'm not sure if you saw it - you said earlier in the thread that you'd be able to add the alternate latching softswitch behavior for 0.941k to the current firmware version - are you still planning on doing that? I know you're busy and I don't mean to bother, just figured I'd ask since it would help me a lot. Thanks a bunch!
hi
yes i can put it up in the coming weeks.
s
multi_s wrote:
yes i can put it up in the coming weeks.
s
Users browsing this forum: No registered users and 4 guests