team awesome! fuzzmachine settings - post them here!

[futuresailors]

There's a setting other than everything maxed?

[monkeydancer]

I was playing earlier and wondered how the clean by itself with the input gain maxed would sound and daaaaaaaang it's a nice bass overdrive. Did not see that coming.

ZERO fuzz? I'm clearly in need of help.

[MEC]

Here is the setting I use with my Mudfuzz VI.

TAFM is following a Pharaoh with it's Fuzz set to zero.

cv - 10
fv - 1
sh - 1
fz - 3
in - 7
sw1 - Left
sw2 - Left

[jwar]

So not really settings, but I did a little minute video of my TAFM with gate off and on. Sounds kind of shitty because I recorded it with my Droid. Whatever. I don't have a fancy smancy IPhone...

Love the feet right? Shit playing and all bros!

[jwar]

Ok I totally can't figure out how to post this without you going to my page. Whatevs...

[Chaosmic]

Here's my favorite setting so far:

in: 10
fz: 2
sh: 1
fv: 10
cv: 12
boost: off
mids: cut

I tweaked the trimmer a bit too, just to see what kind of textural changes I could make. This gives me a gnarly, articulate cutting sound with my Roscoe 5 string (18V pre). A good match for my Oxide and Blunderbuss.....

[electrical]

I like wall of sound, saturated, and thick fuzz, and after a few years of searching I've finally found it in this pedal

My main tone:

In: maxed
fz: maxed
sh: goes between ~9-11 o'clock-ish, ~3 o'clock, and maxed
fv: noon
cv: off, sometimes goes to 2 o'clock if I want
boost: on
mids: depends on how dirty I'm feeling

Like a big, saturated Big Muff, but with more balls. Mids switch really makes my guitar sound stand out in a way that I like very much.

[Eric!]

What I've been using since I got this newest one:

In: 2:00
fz: either max or 1:30
sh: either 10:00 or 1:00
fv: 11:00
cv: 9:30
boost: off
mids: up!

[misc1600]

Fuck > TAFM

cv - 7
fv - 11
sh - 12
fz - 2
in - 2
sw1 - Left
sw2 - Right

[nieh]

in: max
fz: max
sh: 11
fv: 1
sw1: left
sw2: left
cv: 9

[sonidero]

I have the vertical one so I set up like this...

Fuck on what ever into -

TAFM :

FV, CV = 12
SH, FZ, IN = 9
Switches = Down

I'm not sure what this equals on the other version...

Maybe Bri can make a conversion chart, or a TAFM Slide Rule...

[jmoote]

You guys are all crazy with your volume settings. For me, unity gain is always somewhere around 9-10 o'clock on fuzz volume and/or clean volume. Anywhere near/past noon is just insanity.

[smallsnd/bigsnd]

depends on which version you have... on the earlier versions i really should have been using different value pots on the volume controls - it's been ironed out a while ago.

really this thread is ridiculous because since i've been making the TAFM there have been 6 or 7 circuit board revisions with small tweaks here and there. pot values may differ, etc.

[sonidero]

really this thread is ridiculous

You started it...

[smallsnd/bigsnd]

well, it's ridiculous since there have been tweaks!