Circuit n00b here. Always wondered about the clipping indicators on the Red Panda Particle as well as the Drolo Molecular pedals and the Digitech XPs. Good/bad/neither that these lights go off constantly when faced with hot signals/brutal transients?
My gut instinct is to assume it's probably not optimal for these pedals to be constantly clipping. To get around it, I use a Holowon Solvent Blender that lets me dial down the Send volume, then recoup that volume loss after the pedal in question. The XP I have, its gain control gets dialed down just enough and then boosted in an active true-bypass loop.
So who out there clips that shit, or would care to share some (best?) practices on sending signal to these digital beasts?
I eagerly anticipate the to come