AC100CPH and boost pedals

General Gear Discussion - effects, synths, etc.

Moderator: Ghost Hip

Post Reply
Akbarmofo
uncommitted
uncommitted
Posts: 3
Joined: Tue Mar 25, 2008 8:35 pm

AC100CPH and boost pedals

Post by Akbarmofo »

I recently purchased a Vox AC100CPH and play in this band, where there is a need for each of the two lead guitar players to have boost capabilities but the amp makes my former (Over the top boost) and all other pedals I have tried completely useless. The tone of the amp is amazing, I couldn't lose it and start using a distortion pedal. I am going to try my co-workers boost pedal that you made, do you have any reccomendations with this equipment, I would hate to blow off the front part of my amp with a 35 decibel kick to its head. Though I need to figure something out.


Who's got something para me?
spanks
User avatar
starcastic
experienced
experienced
Posts: 802
Joined: Fri Jun 15, 2007 2:03 am
Location: Milwaukee
Contact:

Re: AC100CPH and boost pedals

Post by starcastic »

I play through an old Sunn Concert Lead that was made in the 70's. I usually crank this thing until it's super overdriven on a regular basis. Once as an experiment I plugged in all of my boosts (MXR Micro Amp, Seymour Duncan Pickup Booster, Effector 13 AR 25, and Effector 13 AR 05) and fired them all off to see what would happen...

A lot of unusable feedback. Amp still works perfectly fine. In fact, I use all of these pedals on a regular basis. Just one at a time.

If you're still weary about boosts- my advice to you is to start at the lowest setting and slowly crank the knob until you've reached your desired effect. I'm almost positive your amp will be fine. Vox does nice work.
User avatar
metalmariachi
IAMILFFAMOUS
IAMILFFAMOUS
Posts: 3079
Joined: Sun Nov 26, 2006 6:46 am
Location: Maryland

Re: AC100CPH and boost pedals

Post by metalmariachi »

Are you talking about boosting the top boost side (channel 1) or the high gain side?

If I understand your posting, you’re looking for a clean boost to keep the Vox jangle without coloring any thing. I’d suggest the 0525. You should be able to dial in just the amount you want without pushing the front end into distortion..

Keith
金属マリアッチ
MARIATCHIMETARU

"First we have to make you pretty"
Akbarmofo
uncommitted
uncommitted
Posts: 3
Joined: Tue Mar 25, 2008 8:35 pm

Re: AC100CPH and boost pedals

Post by Akbarmofo »

actually i am trying to get straight decibel boost on the hi-gain side. i tried pinning a volume pedal 3/4 down and just leaning on it when needed but that destroyed what i would dub my rythmic tone. all of the boost and overdrive pedals i have tried do not even register a slight change in the volume. the amp runs them over.

anyone?
on the positive i now have a bad ass over the top boost (vox cooltron) to sell or trade for my possible solution.
Post Reply